I picked up an ECU from Serper3. He was having MAP sensor problems, I'm having them as well.

In the Gauges view I get "-" as manifold pressure. The sensor is getting +5v, has a good ground, but will not vary the signal voltage. Hooking the signal wire for the Adaptronic to my AVC-R's map sensor I get a reading of 276kpa.

This is a dead map sensor, correct? I just want to make sure I'm not overlooking something obvious as I'm new to Adaptronic.


If the sensor's dead, will this one work?
GM 3 Bar MAP Sensor DIYAutoTune.com

Thanks


Sorry for the misspelled thread title. Removing 250ft of cemented in chain link fence doesn't do wonders for finger dexterity the next day.

 

If it is dead, yes, that is the correct MAP sensor.

 

Looks like I'm not alone when I had MAP sensor issues.