Dwell Reducer
02-01-2015, 07:09 PM
#1
Dwell Reducer
I'm looking for a dwell reduction board or module. Running FM-Link w/ Toy cops. First long trip apparently burned out two cops at the 5 hour mark.
(Toyota COP failures confirmed - I replaced all four and the car started and idled nicely.)
(Toyota COP failures confirmed - I replaced all four and the car started and idled nicely.)
Last edited by '95MSM; 02-06-2015 at 10:32 AM.
Reply
0
0
02-06-2015, 03:39 PM
#2
Junior Member
Join Date: Nov 2007
Location: Monterey Bay area
Posts: 53
Total Cats: 2
Have you forund the reducer ?
I have this setup I would like to sell. I can ship to you for $210.
I made it so I could swap the Injector/coil harness, install and go for a '99.
The following is included;
The COPS are the Toyota 90080-19015s, 4 are included
The harness is a '99 spliced with new COP connectors and Caps.
2 of the injector connectors have the clip broken and the injector harness is included.
The Dwell reducer is a Boundary Engineering board, all new components, The '99 coil bracket is included as this is where I mounted the reducer.
The COP bracket is the Track Speed version for the NBs, I only mounted it for fitment
There are nylon spacers for the bracket studs with stainless acorn nuts to position the COPS.
I have this setup I would like to sell. I can ship to you for $210.
I made it so I could swap the Injector/coil harness, install and go for a '99.
The following is included;
The COPS are the Toyota 90080-19015s, 4 are included
The harness is a '99 spliced with new COP connectors and Caps.
2 of the injector connectors have the clip broken and the injector harness is included.
The Dwell reducer is a Boundary Engineering board, all new components, The '99 coil bracket is included as this is where I mounted the reducer.
The COP bracket is the Track Speed version for the NBs, I only mounted it for fitment
There are nylon spacers for the bracket studs with stainless acorn nuts to position the COPS.
Reply
0
0
02-11-2015, 02:05 PM
#3
Junior Member
Join Date: Nov 2013
Location: Sardinia, Italy
Posts: 396
Total Cats: 56
If you didn't found yet, I've got it new
super-easy to install, just wire it between the coils and your ecu and it's done
60€ soldered, 45€ soldering kit plus shipment
Let me know if you want more specs
super-easy to install, just wire it between the coils and your ecu and it's done
60€ soldered, 45€ soldering kit plus shipment
Let me know if you want more specs
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
