Compression Test Results...?
#6
2 Props,3 Dildos,& 1 Cat
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
in case the above weren't clear...
warm up the car
do a DRY compression test first.
then add the drop to teaspoon of oil to the spark plug holes and re run the test.
from the factory service manual:
warm up the car
do a DRY compression test first.
then add the drop to teaspoon of oil to the spark plug holes and re run the test.
from the factory service manual:
COMPRESSION INSPECTION
Warning
2. Charge it again if necessary. (See 01–17–2 BATTERY INSPECTION.)
3. Warm up the engine to the normal operating temperature.
4. Stop the engine and allow it to cool off for about 10 min.
5. Perform “Fuel Line Safety Procedure”. (See 01–14–3 BEFORE REPAIR PROCEDURE.)
6. Leave the fuel pump relay removed.
7. Remove the spark plugs. (See 01–18–3 SPARK PLUG REMOVAL/INSTALLATION.)
8. Disconnect the ignition coil connector.
9. Connect a compression gauge into the No.1 spark plug hole.
10. Fully depress the accelerator pedal and crank the engine.
11. Record the maximum gauge reading.
12. Inspect each cylinder as above.
Warning
• Hot engines and engine oil can cause severe burns. Be careful not to burn yourself during removal/installation of each component.
1. Verify that the battery is fully charged.2. Charge it again if necessary. (See 01–17–2 BATTERY INSPECTION.)
3. Warm up the engine to the normal operating temperature.
4. Stop the engine and allow it to cool off for about 10 min.
5. Perform “Fuel Line Safety Procedure”. (See 01–14–3 BEFORE REPAIR PROCEDURE.)
6. Leave the fuel pump relay removed.
7. Remove the spark plugs. (See 01–18–3 SPARK PLUG REMOVAL/INSTALLATION.)
8. Disconnect the ignition coil connector.
9. Connect a compression gauge into the No.1 spark plug hole.
10. Fully depress the accelerator pedal and crank the engine.
11. Record the maximum gauge reading.
12. Inspect each cylinder as above.
• If the compression in one or more cylinders is low or the compression difference between cylinders exceeds the maximum, pour a small amount of clean engine oil into the cylinder and inspect the compression again.
— If the compression increases, the piston, the piston rings, or cylinder wall may be worn and overhaul is required.
— If the compression stays low, a valve may be stuck or improperly seated and overhaul is required.
— If the compression in adjacent cylinders stays low, the cylinder head gasket may be damaged or the cylinder head is distorted and overhaul is required.
— If the compression stays low, a valve may be stuck or improperly seated and overhaul is required.
— If the compression in adjacent cylinders stays low, the cylinder head gasket may be damaged or the cylinder head is distorted and overhaul is required.
Thread
Thread Starter
Forum
Replies
Last Post