redrider706

iTrader: (4)

Hi All,

I want some feedback on my MS2 build plan.
It is for a 91 with a 94 engine.

Here are a list of mods I am planning to do:
1) Use Abe's adapter board.
It will have the better Schmitt's trigger based input.
Will have switched power for my WBO2.
Will have the idle compensation for A/C
Better PWM idle drivers

2) Build Joe's better spark output with a PNP or a second NPN transistor.

3) Build fan control relay circuit.

4) Electronic boost control. ( This might be a later mod )

5) Mod the intake to fit the IAT sensor.

6) Bigger 305cc supra injectors (might run it at higher fule pressure)

7) I have a question about WBO2 setup.
Should I get a Innovate LC-1 or a JAW/NAW setup?
Anybody with JAW/NAW experience give some feedback?

Thanks in advance.
-Raj

mj71

I have the JAW working with my MS-II

The good: Works great, less expensive
The bad: Was a pain to calibrate, support is forum-based and tends to disappear for long periods, certain firmwares are rumored to have fried WBO2s.

9671111

iTrader: (10)

I've got a JAW currently. It's pretty decent given the price and I really don't have any complaints about it. I wish it were easier to interface with the MS which is why I'm about to replace it with an LC1. But it's possible as mj71 said.

redrider706

iTrader: (4)

Thanks guys.
Mj71, that was my opinion too.

Rccote, what do you mean by wish it was easier to interface with MS?
Do you want to sell the JAW?

-Raj

9671111

iTrader: (10)

I wish it were easier to get them to work together is what I meant, and yeah I'm probably going to sell it soon.