DIYPNP - Cannot calibrate TPS
#1
DIYPNP - Cannot calibrate TPS
Ok so I wired everything together, DIYPNP is properly recognized by the computer.
I plugged the unit into my 93 n/a car. First tried to calibrate things and the TPS was not reading correctly. It's all stock, I changed nothing in the tps.
TPS is grounded with a resistor per the directions on the diypnp board. The TPS does not respond when I press the accelerator and the numbers are all over. Also its buzzing, and the values keep rising no matter what I do and theres no way to make it come back down unless you restart the car.
Do you know what the issue might be?
Thanks!
93 Miata - Stock everything
I plugged the unit into my 93 n/a car. First tried to calibrate things and the TPS was not reading correctly. It's all stock, I changed nothing in the tps.
TPS is grounded with a resistor per the directions on the diypnp board. The TPS does not respond when I press the accelerator and the numbers are all over. Also its buzzing, and the values keep rising no matter what I do and theres no way to make it come back down unless you restart the car.
Do you know what the issue might be?
Thanks!
93 Miata - Stock everything
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM