240_to_miata

iTrader: (2)

Hey guys... i started having connectivity issues with the megasquirt and laptop lately. I am using the usb addapter DIY has on my ms1 v3.0 . they will connect, and stay connected for about a minute... then it just disconnects completely from megasquirt and all the guages are just blank and red (like when you open it if ur not connected)

any ideas?

Braineack

iTrader: (62)

it screwed on tight?

240_to_miata

iTrader: (2)

99 percent sure. im gunna pull it out of the car and make sure the solder points are good and then re-install the usb-serial converter

240_to_miata

iTrader: (2)

the serial connector wasnt tight against the end plate.... so i thought it was tight but it wasnt.

On anouther note... in my datalog in the excel file under "engine" it should just read a 1 if the engine is on right? ill get misclanious 17's and 33's... does this mean something? My car sometimes gets little burps in the megasquirt and is this when it happens? i thought it was just noise in the CAS

richard_ha

http://www.megamanual.com/v22manual/mtune.htm#data

240_to_miata

iTrader: (2)

i knew that was somewhere, i was looking in the wrong spot.. thank you!