MSII v3 + jimstim = no RPM on tunerstudio?
#1
Newb
Thread Starter
Join Date: Jul 2010
Location: Portsmouth, South coast, UK
Posts: 4
Total Cats: 0
MSII v3 + jimstim = no RPM on tunerstudio?
So I have finally built my MSII after the help of this forum and the guides on here - all good stuff!
However, before doing any of the input/output mods etc I thought I would check the build with everything from the megamanual done but no mods. Put the latest firmware on and connected to the jimstim and all seems fine apart from having no RPM, which leads to having no O2, ignition, injector leds etc. A friend of mine has also just built an MSII, the builds look identical and his has the same problem so my guess is the jimstim isnt setup properly for the MSII...?
Has anyone had this problem before and where should I start checking?
Thanks for your help
Ben
However, before doing any of the input/output mods etc I thought I would check the build with everything from the megamanual done but no mods. Put the latest firmware on and connected to the jimstim and all seems fine apart from having no RPM, which leads to having no O2, ignition, injector leds etc. A friend of mine has also just built an MSII, the builds look identical and his has the same problem so my guess is the jimstim isnt setup properly for the MSII...?
Has anyone had this problem before and where should I start checking?
Thanks for your help
Ben
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,079
switched 2 & 3 are up, rest are down.
tach input modes must be done on mainboard.
https://www.miataturbo.net/megasquirt-18/upgrade-ms-i-ms-ii-how-47459/
tach input modes must be done on mainboard.
https://www.miataturbo.net/megasquirt-18/upgrade-ms-i-ms-ii-how-47459/
Thread
Thread Starter
Forum
Replies
Last Post