Had MS out of car, wont start now?
#1
Had MS out of car, wont start now?
Ive had the MS out of the car to copy my mods onto another MS for a mate, before I did, the car worked fine. Finished the new MS, tried it in the car with my map and it wouldnt start. So I changed back to my MS and now that wont start either? While I was checking to see if I was getting a spark, I had the lead 2nd from the bulkhead out and the car started, ran for maybe 15 seconds (not nicely I might add, but then it only had 3 sparks) and now wont start again.
Im getting all 4 leads sparking
Ive tried reflashing firmware (igniter out)
Sending a stock PNP map with just the req fuel adjusted for my injectors
Nothing is working.
Here are two logs from me cranking it.
[ATTACH]no start.xls[/ATTACH]
Im getting all 4 leads sparking
Ive tried reflashing firmware (igniter out)
Sending a stock PNP map with just the req fuel adjusted for my injectors
Nothing is working.
Here are two logs from me cranking it.
[ATTACH]no start.xls[/ATTACH]
#9
Elite Member
iTrader: (1)
Join Date: Jun 2006
Location: Warrington/Birmingham
Posts: 2,642
Total Cats: 42
Harsh and unfair, the lad obviously has an issue with his MS corrupting it's firmware/settings.
Rather than posting unhelpfullymaybe you could offer advice in what might be wrong?
The only thing I can think of is to check allthe solders around the ecu are good etc
Rather than posting unhelpfullymaybe you could offer advice in what might be wrong?
The only thing I can think of is to check allthe solders around the ecu are good etc
Thread
Thread Starter
Forum
Replies
Last Post
elesjuan
Build Threads
9
11-14-2018 12:18 PM