diypnp PLEASE HELP 1991 1.6
#1
diypnp PLEASE HELP 1991 1.6
I've searched all over and I am at a brick wall. I'm sure this is posted somewhere, but I am having an awful time trying to figure out what jumpers, wires that I need to run and WTH pull-ups are (and if i need them). I Have these resistors leftover that I haven't soldered in.
Im running an IAT and MAP.
I just have no idea what to do next... some guidance would me excellent and much appreciated.
Please take a look...
Im running an IAT and MAP.
I just have no idea what to do next... some guidance would me excellent and much appreciated.
Please take a look...
#2
Not sure you're supposed to tap into wled or aled that way, look above the 12V connection, to the left of the big "boot"
You are supposed to install a diode and two resistors across the pullups in the lower right corner, the diyautotune page tells you what and where.
Opto+ gets 470 ohms across to 12V, VR2 470 ohms to 5V, and IAC gets a diode with the banded end across to 12v
See, in the corner?
You are supposed to install a diode and two resistors across the pullups in the lower right corner, the diyautotune page tells you what and where.
Opto+ gets 470 ohms across to 12V, VR2 470 ohms to 5V, and IAC gets a diode with the banded end across to 12v
See, in the corner?
#6
Use this guide and the diyautotune page I provided earlier as a reference as to what goes where. It's more than enough to put it together properly.
Thread
Thread Starter
Forum
Replies
Last Post