Where is the Tach Signal wire
#1
Boost Pope
Thread Starter
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,026
Total Cats: 6,592
Depends on the year.
From '90-'93, the tach signal comes from the igniter, specifically the yellow/blue wire at position D.
For '94-'95.5, it comes from both coils, the black/white wire at each in parallel.
For '96-'97, it comes from the ECU, a black/white wire at position 4L.
For '99-'00, it's at the ECU, green/orange at position 2K.
For '01-'05, the green/orange wire is at position 3O.
On the NA, there is a single-wire sensor on the back of the head to feed the dash gauge, and a separate two-wire sensor for the ECU. On the NB, both sensors are combined into a single housing with a three pin connector- two wires for the ECU sensor and one for the dash gauge. (In all years, the dash gauge sensor grounds through the body of the device, whereas the ECU sensor has an isolated ground.)
From '90-'93, the tach signal comes from the igniter, specifically the yellow/blue wire at position D.
For '94-'95.5, it comes from both coils, the black/white wire at each in parallel.
For '96-'97, it comes from the ECU, a black/white wire at position 4L.
For '99-'00, it's at the ECU, green/orange at position 2K.
For '01-'05, the green/orange wire is at position 3O.
I need info also what sensor the temp gauge on the cluster reads from.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM