Well I'm part way through reading the red build at the moment but I was drawn to this one as I have a non intercooled Turbo 1.6 NA at present that I have an intercooler for so interested to read about the water injection, air intake and intercooler pipework joining and routing. Thanks for the build thread.

 

What were the angles you used to build the cold side of the ic piping?

 

A 90 and a 45. A 90 and a 60 might be better. See https://www.miataturbo.net/showpost....&postcount=185.

 

Hotside in 2" next.[/QUOTE]

What about this side. These two here? 60° and 45°? Do you happen to remember the clr? Looks like the longer standard size radius. Thanks again.

 

See how much better that is, than asking randos on bookface?

 

It's a 45 followed by a 90 going up to the engine. These were all standard bends from siliconintakes.com (Aluminum Pipes).

 

do you see how I posted here first? Waited a few days. 👉👌

 

I really appreciate the replies thank you.

 

Do you have the FCM spring rates? On page 3 you discussed, but did not publish.

And going way back in the thread: I, too have gone to the Bosch (or the present new replacement version) BOV for low cost, and great performance.

 

I "think" it was 550/325. I'll need to do some more searching to tell you for certain.

 

Estimate is fine. Thank you.

 

Another milestone.