TSE EFR NB2 Build Thread
The "low" setting is at 50hz. "high" is at 150.
Turning off flex seemed to fix the issue up until today. I took the mid pipe off to make some adjustments and now the car runs like its on 2 cylinders. Barely starts and will only sorta run for a few seconds before dying. I don't really know how this is possible. The 02 shouldn't be pulling a vacuum at this low of an rpm/cranking.
Logs attached.
2 cylinder mis #1.mlg
2 cyl mis #2.mlg
Turning off flex seemed to fix the issue up until today. I took the mid pipe off to make some adjustments and now the car runs like its on 2 cylinders. Barely starts and will only sorta run for a few seconds before dying. I don't really know how this is possible. The 02 shouldn't be pulling a vacuum at this low of an rpm/cranking.
Logs attached.
2 cylinder mis #1.mlg
2 cyl mis #2.mlg
Car runs now. I suspect one of the plug boots might have popped out. The only thing I did was pull plugs for spark output test mode to confirm I had spark. It checked out so i out it back together and it fired up.
Thread
Thread Starter
Forum
Replies
Last Post
Grifbatenhorst
Build Threads
10
Jan 19, 2016 09:06 PM






