Any need to port the IWG of a high boost 2560?
#23
Elite Member
iTrader: (9)
Join Date: Jun 2006
Location: Chesterfield, NJ
Posts: 6,898
Total Cats: 399
I've ditched my HF $10 die grinder for a $25 Kobalt (Lowes) die grinder. Infinitely nicer. I'm slowly replacing one HF tool at a time...
I use a typical steel bit with an air diegrinder when I port 2560's. I make the hole in the housing almost as big as the flapper hole, maybe 1/16" smaller on the radius. Blend the inlet into the flow as best I can or until I get bored.
I use a typical steel bit with an air diegrinder when I port 2560's. I make the hole in the housing almost as big as the flapper hole, maybe 1/16" smaller on the radius. Blend the inlet into the flow as best I can or until I get bored.
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM