ARTech GReddy Manifold
#21
Elite Member
iTrader: (9)
Join Date: Jun 2006
Location: Chesterfield, NJ
Posts: 6,898
Total Cats: 399
I used to get my flanges from Weirtech, they are laser cut. With regard to the slots into the bolt holes, it was mentioned before and I agree, that these may just be because it's quicker to cut the slot than repierce the material. I ran a waterjet at my last job and it would take much longer to pierce 3/8 steel than cut two 1/4 inch slots. Plus piercing material makes an absolute mess. Next time I get more flanges made I'll ask my local waterjet job shop if it'll be cheaper to make slots into each hole.
Thread
Thread Starter
Forum
Replies
Last Post