Clocking turbo
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: Nov 2009
Location: Toronto, ON
Posts: 1,446
Total Cats: 6
Clocking turbo
Hey guys,
I'm trying to clock the SR20 T28 I just picked up. What is the best method to separate the turbine housing from the centre section? Is it safe to hit it with a hammer, or is it too fragile?
I'm trying to clock the SR20 T28 I just picked up. What is the best method to separate the turbine housing from the centre section? Is it safe to hit it with a hammer, or is it too fragile?
#3
I find that often a few sharp raps on the turbine housing itself with a rubber mallet or even a plain hammer from the side will do the trick. You dont need much actual force, just a sharp impact. Rather than directly trying to pull the sections apart, hitting it from the side applies more force to one specific point. Sort of like with a ball joint and a ball-peen hammer.
#10
Should do the trick.
I got one of these little guys
Heat it up evenly around the spot that's stuck onto the center housing in slow fluid movements, after its damn hot just tap it with something not too strong, like a block of wood or something similar. I've done this to different turbo's a few times now and each time it worked like a charm
I got one of these little guys
Heat it up evenly around the spot that's stuck onto the center housing in slow fluid movements, after its damn hot just tap it with something not too strong, like a block of wood or something similar. I've done this to different turbo's a few times now and each time it worked like a charm
#11
Elite Member
iTrader: (7)
Join Date: Jan 2007
Location: Renton Washington
Posts: 1,731
Total Cats: 4
Should do the trick.
I got one of these little guys
Heat it up evenly around the spot that's stuck onto the center housing in slow fluid movements, after its damn hot just tap it with something not too strong, like a block of wood or something similar. I've done this to different turbo's a few times now and each time it worked like a charm
I got one of these little guys
Heat it up evenly around the spot that's stuck onto the center housing in slow fluid movements, after its damn hot just tap it with something not too strong, like a block of wood or something similar. I've done this to different turbo's a few times now and each time it worked like a charm
Those torches dont heat worth ****. I upgraded to this
#12
Elite Member
iTrader: (28)
Join Date: May 2008
Location: St. Augustine FL
Posts: 2,299
Total Cats: 2
you should've searched I know personally there was like 5 threads when I needed that info.... but to ease your searching I used alot of PB blaster and three days of periodic beatings with a rubber mallet.....
Last edited by p51hellfire; 06-10-2010 at 02:23 AM.
#16
Senior Member
Thread Starter
iTrader: (4)
Join Date: Nov 2009
Location: Toronto, ON
Posts: 1,446
Total Cats: 6
It's an S14 BB T28. 0.60 A/R. Quite a bit bigger compressor than my current T25. I just rebuilt my T25 and it's still smoking. Not sure if my bearing housing is damaged, so I decided to move on to another one. I'll post pics of them side by side later. Pretty sure Brain has a couple of these pics up around here.
Here is some further info. Talk about searcing... ...j/k
http://www.240sxforums.com/forums/sr...rbo-specs.html
Here is some further info. Talk about searcing... ...j/k
http://www.240sxforums.com/forums/sr...rbo-specs.html
Thread
Thread Starter
Forum
Replies
Last Post