Oil and Water lines
Reply
0
0
Elite Member
Joined: Mar 2007
Posts: 5,298
Total Cats: 884
From: Santa Clara, CA
For coolant lines, the cheapest solution is banjos with barbs on the turbo, reinforced silicone hose from mcmaster (search there for high temperature silicone coolant hose, ideally you want 5/16 but I think they only sell 3/8, which is close enough to work), and put the turbo in the line that goes between the mixing manifold and the thermostat neck. You'll wind up having to replace the hoses every few years due to heat, but it otherwise works well. Putting some kind of extra heat shielding on them helps here as well.
For oil return line you need the same reinforced silicone hose but in 5/8".
The oil supply line is the only one with any real pressure in it. I would either buy an an off-the-shelf kit, or DIY it with Earl's parts from summit if I wanted to customize. I don't see the point to using a hydraulic shop, that just sounds like a PITA.
--Ian
For oil return line you need the same reinforced silicone hose but in 5/8".
The oil supply line is the only one with any real pressure in it. I would either buy an an off-the-shelf kit, or DIY it with Earl's parts from summit if I wanted to customize. I don't see the point to using a hydraulic shop, that just sounds like a PITA.
--Ian
Reply
0
0
Yes, you can get your oil and coolant lines at the hardware store, find some copper fittings in the pluming department.
Something like this should work-
Shop EASTMAN 8-ft 1,500-PSI Stainless Steel Dishwasher Connector at Lowes.com
Shop Appliance Supply Lines & Drain Hoses at Lowes.com
Just measure the distance of the lines you need and make sure to get the right length lines, fittings are less important, any fitting will work really you can just use thread tape to insure proper seal, you can drain to atmosphere without issue.
Dont listen to all these newbs, you can build an entire turbo kit at the hardware store, its the new age performance shop!
Something like this should work-
Shop EASTMAN 8-ft 1,500-PSI Stainless Steel Dishwasher Connector at Lowes.com
Shop Appliance Supply Lines & Drain Hoses at Lowes.com
Just measure the distance of the lines you need and make sure to get the right length lines, fittings are less important, any fitting will work really you can just use thread tape to insure proper seal, you can drain to atmosphere without issue.
Dont listen to all these newbs, you can build an entire turbo kit at the hardware store, its the new age performance shop!
Reply
1
1
It would be sweet if we could compile a part list for some popular engine and turbo setups though. Could cut down on the amount of these threads we see.
Something like:
1.6L T25 Turbo's use
-X Water line with X fittings etc.
-Y Oil line with Y fittings etc.
Something like:
1.6L T25 Turbo's use
-X Water line with X fittings etc.
-Y Oil line with Y fittings etc.
Reply
0
0
Sounds easy, but every moron who tries to use an oddball turbo would still ask the same question. Besides, all you do is use a thread check, or take it to a shop who can. That's after you fail at google, which has all of the information in like .043 seconds.
Reply
0
0
Yeah. We've tried this before. This assumes that the n00bs will put forth enough brainpower and dedication to actually read through various threads and learn various things.
Huge and foolish assumption
Huge and foolish assumption
Reply
0
0
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
