i just finish the turbo set up on the car and getting ready to start it. im running ms/extra parallel with stock ecu. prob is im running gm air temp and water temp sensors and i got the map vac line i got to run threw the fire wall and im not seeing any ware to pass them threw. i mean the engine harness passes threw but its all the way behind the blower and looks impossible. any ideas? i would ready appreciate the help trying to get my car on the road.

 

Where the engine harness goes into the car on passenger side.. its *NOT* easy but I have fished several vacuum lines through there before. I poked a small hole in teh rubber boot with a coat hanger and fished it out from inside. Tape your line to the hanger and carefully pull it through. Its a PITFA though.

 

Beautiful Exhaust Manifold.
I second the location elesjuan is talking about. I removed the glovebox, it helped allot!

 

Holy big downpipe batman.
I run my wires through a grommet on the firewall by the clutch resevoir but only because my MS is on the driverside.

 

I want your dads 911!!!

 

Haha yeah I sent you a PM elaborating on how awesome that car is!

 

WHere the throttle cable goes through you can stick plenty of wires through, or on the passenger side on the firewall there are a few grommets that will allow passage through.

 

Seriously, would you pleeeease list the specs for that motor.
That looks like a 4" dump pipe... I hope you're gonna have the clearance for it.

 

I run through the old cruise hole and once that is full out comes the drill and another hole goes in for increased lightness and more wire claerance that is some pretty sweet **** man.