spending all my high school income on a 30 year old car
#21
Heres a little plot twist, woke up this morning to find 3 broken FAB9 headstuds and a **** load of broken glass around my engine, looks like a glass tube light fell off the ceiling in my garage and hit my engine....not sure how this broke THREE torqued down headstuds. Ive already ordered ARP hardware and extracted the two bolts which were protruding once I pulled the head, unfortunately one is buried about 1cm deep in the block and I am completely lost on my next steps.
#22
Elite Member
iTrader: (13)
Join Date: Dec 2006
Location: Taos, New mexico
Posts: 6,634
Total Cats: 587
That is nuts man. I assume you are talking about ARP studs from FAB9? I'm running the same kit, no issues with mine. That must have been a hell of a hit, or they were overtorqued/fatigued and just waiting to snap. Weird.
#23
Nah it was actually the FAB9 brand ultra duty headstuds which I bought over ARPs because of availability and because Greg@thecarpassionchannel chose to use them over arps in his latest build. The one stud broken in the head luckily wasn’t too hard to get out and my ARPs are supposed to come today with my supermiata trigger wheel.
#31
im back... going home from college in late May, and i have until the end of September to get this car sorted because I really fckn want to take it down to santa barbara next year. Currently: engines in, all lines are run apart from turbo oil drain, 5 speed trans still in there with an ACT 4 puck + lightweight flywheel and a custom 3 inch exhaust has been run with the big *** magnaflow. didn't get a chance to touch any electrical before I left for college. Want to get this thing geared to get 'decent' freeway mileage - anyone have experience with 6spd + 3.3 at around ~300whp? if the best move at this point is to go getrag, I want to get a headstart on ordering parts soon.
Thread
Thread Starter
Forum
Replies
Last Post