Twinscroll worth it?
#102
Racing RX-7's, if the car is non-turbo, nobody touches the turbo transmissions because of the tall gears and the uber-lack of torque. But with turbo, the torque is not as much of an issue.
#103
After I built the motor the 2560 wasn't enough. So after a lot of research I decided on using the MHI Twin Scroll TD05HR-16G6 10.5T. Reasonable priced, rebuild costs aren't bad. I been super happy with this choice. The spool up is great. (I want your spool data post #219)
That said, the header was a challenge to fabricate, so I would vote yes to a cast manifold for others to try this segment of turbos.
I don't know the answer to this but since most people start with stock motors would this flange fit other MHI turbos so as you upgrade the motor you could still keep the manifold and choose a higher flow turbo as necessary. Also the exhaust spacing between Mitsubishi and the BP4W head is very similar so maybe there are two potential markets here.
For what it's worth, here's the link to my set up:
https://www.miataturbo.net/diy-turbo...o-build-79259/
Cheers,
-JB
That said, the header was a challenge to fabricate, so I would vote yes to a cast manifold for others to try this segment of turbos.
I don't know the answer to this but since most people start with stock motors would this flange fit other MHI turbos so as you upgrade the motor you could still keep the manifold and choose a higher flow turbo as necessary. Also the exhaust spacing between Mitsubishi and the BP4W head is very similar so maybe there are two potential markets here.
For what it's worth, here's the link to my set up:
https://www.miataturbo.net/diy-turbo...o-build-79259/
Cheers,
-JB
Thread
Thread Starter
Forum
Replies
Last Post