DIY Turbo Discussion greddy on a 1.8? homebrew kit?

Problems after turbo install

Thread Tools
 
Search this Thread
 
Old 06-10-2010, 05:29 AM
  #1  
Junior Member
Thread Starter
iTrader: (2)
 
linuxbox's Avatar
 
Join Date: Nov 2008
Posts: 226
Total Cats: -14
Default Problems after turbo install

I installed my turbo setup with a Link ECU and just got the IAT sensor hooked up - so I figured I'd try starting it even though the big injectors aren't in yet. I turned the key to on - and the dash lights come on - then I turn the key to start and I hear one click from the starter maybe- then all the lights turn on until I have the key back to on. So I figured it could be the battery, I charged it all night. This morning when I try now - I turn the key to start and the lights all go off - not even a click from the starter. Could this be my battery? The charger shows it as being fully charged, Anybody have any ideas? Also- if I turn on the headlights - they will be bright until I hit the brake and then they dim - the other lights dim then come back to full brightness except the headlights. Could it be a ground issue? The only step I skipped during the ECU install was to add a ground like the manual says - could this be the problem? I appreciate any help - it'll save me from trouble shooting with a new $80 battery.
linuxbox is offline  
Old 06-10-2010, 10:06 AM
  #2  
Elite Member
 
dustinb's Avatar
 
Join Date: Feb 2008
Location: Victoria, BC
Posts: 2,320
Total Cats: 13
Default

It's a ground issue. Make sure the main ground is on your battery in the trunk. A lot of times that line also brakes off from where it mounts to the car.
dustinb is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
zephyrusaurai
Meet and Greet
2
09-28-2015 10:59 PM
btabor
ECUs and Tuning
10
09-28-2015 05:33 PM
AdoboMiata
MEGAsquirt
4
09-22-2015 02:32 AM



Quick Reply: Problems after turbo install



All times are GMT -4. The time now is 06:00 AM.