Shanghai-s at 9.75psi
07-17-2012, 02:05 AM
#1
Junior Member
Thread Starter
Join Date: Oct 2009
Location: Anderson, SC
Posts: 330
Total Cats: -3
Shanghai-s at 9.75psi
Thought I might as well post this up here because everyone seems so surprised by the results. Car is a 99 with ebay fmic, Brain ms, 460cc rx7 injectors, and straight through enthuza 3" exhaust, cast manifold, t25/28 chinacharger.
Edit: if you can't see its 241hp and 207ft-lbs.
Edit: if you can't see its 241hp and 207ft-lbs.
Last edited by cowboys647; 07-17-2012 at 02:06 AM. Reason: Adding numbers
Reply
0
0
07-17-2012, 08:47 AM
#2
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,080
watch out with that fuel creeping back lean as you get towards redline.
Next time, tune out the dip by moving the VICS de-activation point.
and next time, tell them to scale the hp and tq on the same scale. Can you get the .drf files from the dyno shop?
Next time, tune out the dip by moving the VICS de-activation point.
and next time, tell them to scale the hp and tq on the same scale. Can you get the .drf files from the dyno shop?
Reply
0
0
07-17-2012, 07:06 PM
#3
Junior Member
Thread Starter
Join Date: Oct 2009
Location: Anderson, SC
Posts: 330
Total Cats: -3
Yea I saw it starting to go lean. Kinda odd because during normal pulls my wideband never showed it starting to lean out. Once I get my new actuator installed I'm bringing my car back to Begi to tune it cuz its still a real rough tune atm. It was a dyno day so all I got was the print out but next time I go I'll make sure to get it scaled right. Out of curiosity what are the .drf files?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
cowboys647
General Miata Chat
21
07-17-2012 07:12 PM
Full_Tilt_Boogie
Prefabbed Turbo Kits
26
07-14-2009 04:21 PM
Full_Tilt_Boogie
Meet and Greet
26
06-25-2009 09:48 AM
