Ok so I'm at the point with my car where I'm ready to put the standalone in and I have the Haltech ECU and engine harness but I don't know what other wires I have to splice/tap into to get everything working. I'm also unlooming the entire harness and deleting pretty much everything I'm not using. AC, air bag, AFM etc etc and going to tuck all the wires away for a clean install. Any help is appreciated cause I'm no wiring guru but I'm also not retarded just don't want to mess anything up. Thanks gheys

 

Did you ever figure this out? Have several Haltech/Miata installs under my belt. Can assist if you need it.

 

No I ended up parting out the car. Gonna put the Haltech on my SC300 soon though

 

Install instructions for a 1.6L and a Haltech Sprint 500

http://www.lms-efi.com/haltech/ems_install.pdf