Hey all, trying to get a perfect tuning universal gauge (https://perfecttuning.net/en/gauge/5...sal-gauge.html) to work with my mspnp2, specifically i need it to display afr. Ive been told to look for a setting in tunerstudio called dash broadcasting but cannot find it. Any advice?

 

It's under the CAN settings somewhere. I don't have TS on this machine, but it's in there. Is everything physically wired up?

 

I had looked under can bus/ test modes but didnt see it, ill double check when i get my laptop working again

 

I am pretty sure if you go to the perfect tuning website and download their manual they have step by step instructions to get it working with megasquirt. I know a few years ago when I bought mine I followed the instructions to get it working with my MS3.

 

Thats what I was doing, I'm just stuck on where the option for it is in ts.

 

You likely need a firmware update for the feature to be available.

 

Alright, so i reinstalled ts and now if i open an example project, the option for dash broadcasting shows up where it should be, but when i open the project for my car it goes away again.

 

As per my last email

 

I hope you understand there’s a difference between updating TS and updating the firmware that’s running on your MS.

You need to update your firmware.

 

Yep, updated the firmware on ms and i got several error messages. Didnt have time to figure it out at the time, but now ms isnt being detected by ts...

 

Alright i got the firmware stuff figured out and dash broadcasting is now available. Still cant find a base map that works.

 

Nevermind, got it running. now i have dash broadcasting enabled but its still not showing on the gauge and i have some awesome new lifter tick