Mounting wells tps210
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2012
Location: Moscow, PA
Posts: 118
Total Cats: 2
Mounting wells tps210
How does the tps mount to the plate? How does it detect the throttle position, I am not comprehending this, also my sensor slides over the throttle shaft without needing to file anything to fit like the "how-to" states.
Should the tps rotate with the throttle shaft?
Does washer/post combo need to be cut off so the tps can sit flush on that mounting plate?
Is that yellow plastic collar piece required in the right side of the photo?
Should the tps rotate with the throttle shaft?
Does washer/post combo need to be cut off so the tps can sit flush on that mounting plate?
Is that yellow plastic collar piece required in the right side of the photo?
#3
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2012
Location: Moscow, PA
Posts: 118
Total Cats: 2
Your photo shows a "D" type opening that keys into the throttle shaft which I do not have. I am still unsure how this reads the position, it appears yours is mounted on top of that post where the old plastic mounted was mounted (shown in second photo), is that correct?
#4
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,080
mine's not the same Wells are yours.
I need to find the one ggreg used and update the post with that. it has the correct shaft key like the one i edned up with.
Notice on Ben's writeup that you need to shave the center to fit the TB's "D-shaped shaft...
I need to find the one ggreg used and update the post with that. it has the correct shaft key like the one i edned up with.
Notice on Ben's writeup that you need to shave the center to fit the TB's "D-shaped shaft...
#17
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2012
Location: Moscow, PA
Posts: 118
Total Cats: 2
Ended up using the tps210, see my link below for how I mounted it
https://www.miataturbo.net/megasquir...install-67899/
https://www.miataturbo.net/megasquir...install-67899/
#18
Ancient thread... But I am attempting to get some stuff installed today and my Wells TPS is on my list. Will this thing work with the stock ECU? I'm doing this at my work's garage and if I cant get up and running on my MS I will have to swap back to the stock ECU to get home.
Last edited by BTMiata; 11-13-2013 at 12:43 PM.