The car ran fine on older firmware, I updated the firmware to the correct version and loaded up my tune and project settings and now the car wont start.
I am not geting a RPM Signal in tunerstudio this is a rev built Ms2e.
I am putting the tune i use bellow and a log of me cranking it, This is my daily driver and i need it running asap.
New Fim Tune.msq

112015-09-04_10.33.05.msl

 

I plugged in the stock ecu and the car started right up so all my important sensors seem to be working, any ideas on what could be going on

 

I loaded up diy auto tune base map and I am still getting no rpm signal in tuner studio, does anyone have a basemap for a 99-00?

 

Anyone?

 

Can you post a composite log of an attempted start?

Is Rev helping out? These have a lot of his own custom work and he's really the only one with complete details.

 

I will post that when I get home from work,I don't have his email I haven't personally asked him for help yet but if I don't figure this out of will.