engine swap- will not start
#1
Junior Member
Thread Starter
Join Date: Jul 2008
Location: Bergen County NJ
Posts: 103
Total Cats: 0
engine swap- will not start
Just recently swapped my motor with a 94-95 jdm engine, due to my previous engine over boosting and bending a rod from the signal line to the WG popping/breaking off.
put the engine in, connected all the connectors. car will turn over but will not start. what could be wrong? i do not think i am getting any spark. i am using the same engine map that used previously that started up and idled very well. What could be causing me to not have spark? are there any grounds i could have possibly missed? i can here the fuel pump priming and i believe i have fuel. Thanks.
put the engine in, connected all the connectors. car will turn over but will not start. what could be wrong? i do not think i am getting any spark. i am using the same engine map that used previously that started up and idled very well. What could be causing me to not have spark? are there any grounds i could have possibly missed? i can here the fuel pump priming and i believe i have fuel. Thanks.
#6
Junior Member
Thread Starter
Join Date: Jul 2008
Location: Bergen County NJ
Posts: 103
Total Cats: 0
wouldn't the plugs be wet if i was getting required fuel for start up? maybe im just smelling old fuel..... ill try new plugs the iridiums in my old motor are fairly new i will swap those in though just to eliminate possibilities...
Thread
Thread Starter
Forum
Replies
Last Post