DIY manifold
#421
Sturovo,
Thanks for the good catch, you are correct on both counts I had it marked on the gasket but failed to offset the two top center bolt holes on the drawing.
I would have noticed the problems on the thin gauge steel part that am getting made just to check for problems like this, but it is best to start with the proper dimensions in the first place.
Thanks again
Thanks for the good catch, you are correct on both counts I had it marked on the gasket but failed to offset the two top center bolt holes on the drawing.
I would have noticed the problems on the thin gauge steel part that am getting made just to check for problems like this, but it is best to start with the proper dimensions in the first place.
Thanks again
#422
Elite Member
iTrader: (8)
Join Date: Dec 2008
Location: Kingston, Ontario
Posts: 2,910
Total Cats: 51
Thread
Thread Starter
Forum
Replies
Last Post
Nagase
DIY Turbo Discussion
84
02-05-2011 11:58 AM