Cam Cover Spruce Up
#45
I'm just going to use the 3 stock holes already in the Valve cover... the ones one the end of the #1 and #4 plug, and the one between #2-#3.
There will be a holddown plate that goes on top of the COPS and three spacers. The key is the depth of the bolt/spacer. You want the plate to sit tight on the spacer so that it functions to keep the valve cover tight against the head, but you don't want the plate crushing the COPs.
I'm getting better at paint, but I hope this gets the idea across:
There will be a holddown plate that goes on top of the COPS and three spacers. The key is the depth of the bolt/spacer. You want the plate to sit tight on the spacer so that it functions to keep the valve cover tight against the head, but you don't want the plate crushing the COPs.
I'm getting better at paint, but I hope this gets the idea across:
#46
2 Props,3 Dildos,& 1 Cat
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
same how I did it kinda. only i used the 01 coil mounting holes.
http://flickr.com/photos/55387619@N0...7602596105121/
do yourself a favor and go to the home deep and get some aluminum tubing that fits over the (8mm??) bolts so you can make spacers. it's cheap. you can see it in mine.
http://flickr.com/photos/55387619@N0...7602596105121/
do yourself a favor and go to the home deep and get some aluminum tubing that fits over the (8mm??) bolts so you can make spacers. it's cheap. you can see it in mine.
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
StratoBlue1109
Miata parts for sale/trade
7
09-24-2015 03:50 PM