Dynoed @ 136whp
08-31-2008, 01:14 AM
#1
Junior Member
Thread Starter
Join Date: May 2007
Location: Homestead Fl.
Posts: 92
Total Cats: 1
Dynoed @ 136whp
as requested my car made 136whp in mid april i believe, my car is mostly stock. All that was done to it was, a filter replacing the whole air box assembly, gutted cat, no muffler, and i changed the crystal to allow my car to rev higher. the power was made @ 8000 rpm indicated. That is honestly all that was done to it that i know of. the only difference between it now and then is that i put the muffler back on.
Reply
0
0
08-31-2008, 01:33 AM
#6
Junior Member
Thread Starter
Join Date: May 2007
Location: Homestead Fl.
Posts: 92
Total Cats: 1
nope no pulling number outta my ****, i got it dynoed on a Suprflow 810
and this is the shop that i did the pull at http://www.performancechassisdyno.com/
also this is my car on the dyno
and this is the shop that i did the pull at http://www.performancechassisdyno.com/
also this is my car on the dyno
Reply
0
0
08-31-2008, 11:42 AM
#7
My bet is 136hp at the motor, or the dyno operator fudges the #'s. No way a semi stock motor will make 136 at the wheels. That is close to 170hp at the motor. I had a blower w/9 psi, water injection, a timing controller and I dyno'd 150.1 rwhp on a dyno dynamics. That is about 172rwhp on a dynojet since they are bogus. Use that reverse logic and you are around 116rwhp.
Reply
0
0
08-31-2008, 12:03 PM
#8
Redrum, you got hosed by your dyno operator... plain and simple. Its pretty common with a stock car and a motivated operator to tell a customer exactly what he wants to hear... especially if the customer has extremely high expectations of his "mods". The stock Miata intake system is extemely well designed and swapping to an aftermarket CAI or deleting the stock airbox is worth very little. Pulling your muffler might make you a pony or two up high, but is probably hurting a bit of low-end torque. And if you'll seriously look at some of the FM dyno-plots in the other thread, you'll see that Miata's make peak hp by about 6500rpm. NO WAY you made peak power at 8k.
Even though Miatas aren't dyno'd stock all that often, any competent operator would know the cars don't make that much power stock. $15k Rebello Spec Miata motors make that much, but not your stock(ish) one. Sorry hoss, I wouldn't again advertise that you made 136whp on a stock motor unless you want to get **** on again. Do yourself a favor and take it to a place with a Dynojet and pay the $50 for 3pulls. Tell the operator you want the uncorrected and corrected numbers, and don't go back to that other shop.
Even though Miatas aren't dyno'd stock all that often, any competent operator would know the cars don't make that much power stock. $15k Rebello Spec Miata motors make that much, but not your stock(ish) one. Sorry hoss, I wouldn't again advertise that you made 136whp on a stock motor unless you want to get **** on again. Do yourself a favor and take it to a place with a Dynojet and pay the $50 for 3pulls. Tell the operator you want the uncorrected and corrected numbers, and don't go back to that other shop.
Reply
0
0
08-31-2008, 01:59 PM
#9
Junior Member
Thread Starter
Join Date: May 2007
Location: Homestead Fl.
Posts: 92
Total Cats: 1
Redrum, you got hosed by your dyno operator... plain and simple. Its pretty common with a stock car and a motivated operator to tell a customer exactly what he wants to hear... especially if the customer has extremely high expectations of his "mods". The stock Miata intake system is extemely well designed and swapping to an aftermarket CAI or deleting the stock airbox is worth very little. Pulling your muffler might make you a pony or two up high, but is probably hurting a bit of low-end torque. And if you'll seriously look at some of the FM dyno-plots in the other thread, you'll see that Miata's make peak hp by about 6500rpm. NO WAY you made peak power at 8k.
Even though Miatas aren't dyno'd stock all that often, any competent operator would know the cars don't make that much power stock. $15k Rebello Spec Miata motors make that much, but not your stock(ish) one. Sorry hoss, I wouldn't again advertise that you made 136whp on a stock motor unless you want to get **** on again. Do yourself a favor and take it to a place with a Dynojet and pay the $50 for 3pulls. Tell the operator you want the uncorrected and corrected numbers, and don't go back to that other shop.
Even though Miatas aren't dyno'd stock all that often, any competent operator would know the cars don't make that much power stock. $15k Rebello Spec Miata motors make that much, but not your stock(ish) one. Sorry hoss, I wouldn't again advertise that you made 136whp on a stock motor unless you want to get **** on again. Do yourself a favor and take it to a place with a Dynojet and pay the $50 for 3pulls. Tell the operator you want the uncorrected and corrected numbers, and don't go back to that other shop.
Reply
0
0
08-31-2008, 05:08 PM
#16
Junior Member
Thread Starter
Join Date: May 2007
Location: Homestead Fl.
Posts: 92
Total Cats: 1
i was pulling to 8k because we were running it from i think 40 mph to 90 mph or so and if i remember correctly it was only corrected standard temperature and pressure.
and ill stake my skeptical claim of 136whp. like i said, that was alot more than i was expecting, although i would like to go to another dyno and get another pull to confirm my numbers or disprove my numbers.
and once i get back to Eastman Ga ill post my sheets asap.
and no to the ban.
and once i get back to Eastman Ga ill post my sheets asap.
and no to the ban.
Reply
0
0
08-31-2008, 05:41 PM
#18
I'm finding it hard to believe that in the presence of OVERWHELMING evidence you won't let this go. You appear downright dense. As I said, the $15k Rebello Spec Miata engines make that much. If you think somebody stuck one of those in your car, then you should post it up HERE immediately, and re-invest the proceeds into your '01. Otherwise, you should let this thread go.
Reply
0
0
08-31-2008, 06:03 PM
#19
I tell you what, go over to Dynolab in Marietta on a Thurs. night and hand over your $50 and see what happens. They're accurate for getting numbers.
8K? You do know what is required to make a BP rev to 8k, right? I want to see you take a camera out to your car and video the tachometer goign to 8,000 rpm.
I'm willing to bet that $50 that someone didn;t have all the settings right when you dyno'ed. Hell, I was playing around on a dyno and put in one little wrong command and went from 115rwhp/112tq to 145rwhp and 300tq lol.
8K? You do know what is required to make a BP rev to 8k, right? I want to see you take a camera out to your car and video the tachometer goign to 8,000 rpm.
I'm willing to bet that $50 that someone didn;t have all the settings right when you dyno'ed. Hell, I was playing around on a dyno and put in one little wrong command and went from 115rwhp/112tq to 145rwhp and 300tq lol.
Reply
0
0
