Dyon'ed our 99 today
#23
Elite Member
iTrader: (24)
Join Date: Jun 2007
Location: Woodland Hills, CA
Posts: 4,667
Total Cats: 18
not sure i would want any kind of 10-years-old plastic pieces with small sensors that always see pressure applied to them sitting next to my throttle body. god forbid something would go wrong and you suck part of that thing into your engine!
#26
Attachment 203725
Attachment 203726
Attachment 203727
Last edited by 18psi; 03-26-2018 at 12:32 PM.
#28
Elite Member
iTrader: (1)
Join Date: May 2009
Location: Jacksonville, FL
Posts: 5,155
Total Cats: 407
I wouldnt be concerned about it failing.
Running it blow through actually makes a lot of sense from a piggy back tuning perspective. draw through it quickly becomes maxed out on flow, so youre essentially on the highest load cells of the stock ecu's map and simply ramping up the fuel of that map with the MAPP sensor signal. But if you make it blow through youre still able to accuratly meter velocity and simply compensate with MAP.
With the mild 'tunes' many people have on their standalones this kind of setup could be nearly as good, with the exception of the limited injector size compensation...
Running it blow through actually makes a lot of sense from a piggy back tuning perspective. draw through it quickly becomes maxed out on flow, so youre essentially on the highest load cells of the stock ecu's map and simply ramping up the fuel of that map with the MAPP sensor signal. But if you make it blow through youre still able to accuratly meter velocity and simply compensate with MAP.
With the mild 'tunes' many people have on their standalones this kind of setup could be nearly as good, with the exception of the limited injector size compensation...
#30
I'm Miserable!
iTrader: (16)
Join Date: Dec 2008
Location: where most people are Utarded
Posts: 1,296
Total Cats: 0
There is a local Festiva that has been converted to RWD using an Escort GT motor and Toyota solid rear axle, 60 trim t3 and a blow through AFM. It runs solid 12's in the 1/4.
#31
i made that assumption too wen i had to change the maf out of the legacy. but theyr actually made of metal. it just looks like plastic cuz of the weird colour. for one year 99' they did make em out of plastic. but nowa days they could be all made of plastic since they change the intake mani to plastic.
#33
What size injectors? I thought the Emanage was limited in injector size. Could be an Emanage Ultimate I guess.
Frank
Thread
Thread Starter
Forum
Replies
Last Post