forged pistons and better rods...or no?
05-09-2007, 09:55 PM
#21
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
he means that is the end of being cheap with the car. from then on you will want to spend good $ on it. I do not believe he is as familiar with your goals and research as the rest of us though if you must go 1.8 get a 99 head to flow better. personally i would keep the 1.6 and rebuild it over the winter when ever but this is just my taste GL man. FWIW with balance blueprint etc wiescos and stock rods my build ran about 2K with seals and ARP head studs bearings included. 
Reply
0
0
05-10-2007, 07:59 AM
#23
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
line bore, bore on a torque plate, balancing, 3 angle valve job, and new valve stems / seals. The guy has built a few motors for my father, and its always $1000 in labor for a big block v8.
Reply
0
0
05-10-2007, 10:09 AM
#25
Buy a new harmonic balancer while you're at it. The old one may look good, but the rubber is probably shot. Cheap insurance. New oil pump, water pump, timing belt kit as well. Don't care how new the stuff on the engine is, it's apart so get new parts. ARP makes rod bolts now fyi. New OEM main and head bolts are as much as ARP studs, so I recommend ARP head and main studs. Reusing those fasteners from the engine is silly.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
