Erratic AFR readings with Innovate LC-1?
#1
Elite Member
Thread Starter
iTrader: (24)
Join Date: Jul 2007
Location: Cypress, TX
Posts: 3,759
Total Cats: 35
Erratic AFR readings with Innovate LC-1?
I've had this thing installed since 2008, and it has always done this. I just didn't ever figure this was a problem because the car drives well when tuned using VEanalyze.
LC-1 has been recently calibrated, out of the pipe. <1600 miles ago
Sensor and heater grounds are soldered at the ECU connector's sensor and general ground wires respectively. This fixed a ground offset, but did not fix the noise, which I wasn't trying to fix anyway. Previously, it was grounded at the intake manifold on separate lugs.
Logworks shows the same noise. MS and the DB gauge agree.
This Screenshot is with the engine off and key on after idling 5 minutes earlier. I set a 1/6th Second aggregation delay in LM programmer for this pic. It didn't improve things.
Here are some running logs for you.
http://www.mediafire.com/file/vg4sb9...oisy%20AFR.msl
http://www.mediafire.com/file/f6kawo...ttering.56.msl
And my tune.
http://www.mediafire.com/file/uzvbm1...urrentTune.msq
The same variation is shown in logworks and while the engine is running. Is this abnormal? How can I fix it?
What do?
LC-1 has been recently calibrated, out of the pipe. <1600 miles ago
Sensor and heater grounds are soldered at the ECU connector's sensor and general ground wires respectively. This fixed a ground offset, but did not fix the noise, which I wasn't trying to fix anyway. Previously, it was grounded at the intake manifold on separate lugs.
Logworks shows the same noise. MS and the DB gauge agree.
This Screenshot is with the engine off and key on after idling 5 minutes earlier. I set a 1/6th Second aggregation delay in LM programmer for this pic. It didn't improve things.
Here are some running logs for you.
http://www.mediafire.com/file/vg4sb9...oisy%20AFR.msl
http://www.mediafire.com/file/f6kawo...ttering.56.msl
And my tune.
http://www.mediafire.com/file/uzvbm1...urrentTune.msq
The same variation is shown in logworks and while the engine is running. Is this abnormal? How can I fix it?
What do?
Last edited by Bryce; 05-04-2011 at 05:18 AM.
#2
Elite Member
Thread Starter
iTrader: (24)
Join Date: Jul 2007
Location: Cypress, TX
Posts: 3,759
Total Cats: 35
Am I too confusing?
After 1600 miles on this motor, I got a code 8 a few times today. I'm going.to do a full recalibration of the heater circuit.
Do me a favor and take a log with your engine off after running for a minute. How much does your afr reading waiver?
After 1600 miles on this motor, I got a code 8 a few times today. I'm going.to do a full recalibration of the heater circuit.
Do me a favor and take a log with your engine off after running for a minute. How much does your afr reading waiver?
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM