So olderguy's sending me my 1.8L injectors and i don't know where to start with the install.......i'm assuming they just plug and play once they're in there but what all do i have to remove to get them out just the fuel rail or does the intake manifold have to come out also? Do the injectors just pop out by pulling on them or what do i have to do to get em outta there? will i have to make any other adjustments (i.e. to the maf?) to get them running right?

sorry for all the jumbleed up questions....just woke up. Thanks in advance for any input

 

remove that port on the side of the intake manifold (4 8mm bolts). Then unscrew the rail (2 12mm bolts) Dont let the spacers drop. pull out the vacuum line to the pcv. Unplug the injectors, lift the rail and pull out the old injectors. Oil the o-rings on the new injectors and slide them in. Put it back together. Shouldn't take more than 15-30mins. This is assuming you have an M1

 

See this is why i love this site....i posted this, went and got a drink outta the kitchen, came back and refreshed the page and i already had a lengthy reply!!! Much better than m.net, LOL

Thanks braineack

 

don't forget to loosen the gas cap first. it will depressurize the fuel system.

 

Took out the old ones before this was posted.....so of course i never thought about it.

yea....well.....i dropped one........not fun to try to find in a garage as dirty as mine.......but i did


Yea, i suck, LOL

 

I only said it cause of experience with them falling.

 

Nope. Gas cap does not depressurize anything at the fuel rail. To depressurize the rail need to pull the CIR at idle.

Can scroll down to the 5th pix on this page: http://bellsouthpwp.net/P/o/PopVII/filter.htm

 

atleast you didn't have fair warning, LOL

Did you find yours or have to find new ones?

 

splash shield is your friend.

 

yea....especially if you're like me and took yours off a couple months ago........