Wiring a 1.6 harness into a 99 TB-VTPS
#1
Elite Member
Thread Starter
iTrader: (15)
Join Date: Sep 2007
Location: Incline Village, NV
Posts: 2,034
Total Cats: 5
Wiring a 1.6 harness into a 99 TB-VTPS
I have a 1.6 car and ill be putting another 1.8 motor into it shortly. One of the issues I am unable to find on my own is how i should go about wiring the tps harness from my car (again 1.6) to a 99 TB.
I had a 1.6 auto TB that i bought from Joe a while back, but that doesn't want to play nice with the 99 intake mani.
Has anyone done this?
I had a 1.6 auto TB that i bought from Joe a while back, but that doesn't want to play nice with the 99 intake mani.
Has anyone done this?
#6
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,080
does that help?
connect the signal wire of the TPS to the LG/W white at the harness.
connect the 5vref wire of the TPS to the R wire at the harness.
connec the ground wire for the TPS to the remaining ground wire in the harness.
connect the TPS signal wire for the MS to 2L
connect the 5vref signal wire for the MS to 1N
#7
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,046
Total Cats: 6,607
For M/T:
B/LG = GND
R = Idle (closure to ground when throttle fully closed)
LG/W = Power (closure to ground when throttle fully open)
For A/T:
B/LG = GND
R = Idle (closure to ground when throttle fully closed)
LG/R = +5v
R/B = analog output (0-5v, increases with throttle opening)
Thread
Thread Starter
Forum
Replies
Last Post