nofear

Hello, I am nofear.
Scrixo Italy, Calabria.
My miata:
2005, 1.6.
1 mm oversize valves fly miata.
MP45 with EMB by Phil P5.
Fidanza flywheel, Spec clutch satge 2 plus.
drain line craftsmanship.
LPG.
Sorry for not perfect English

18psi

iTrader: (76)

Welcome.
Looks like a decent daily driver setup.

Any plans to turbo?

shuiend

iTrader: (24)

Please put your location in your user control panel, that way we see it everytime you post and we will not hassle you for bad grammer.

Welcome to the forums. Start reading all the sticky's now and you will be fine.

dustinb

Welcome to the board. That dyno image is really small and I can't make out the power. What kind of numbers are you making?

greendrifter

if i've translated correctly - it looks like 177cv at the shaft and 133cv at the wheels,

is there a rule of thumb, regarding power loss from the two readings, i'm pretty new to dyno's,

my DIY turbo set up was putting out 167hp at the engine and 138hp at the wheels, does this seem in line with the norm?

and welcome nofear ,

Gotpsi?

iTrader: (5)

Welcome seems like we are gaining members from you side of the pond.

dustinb

138HP at the wheels for a turbo setup is very low. Even the most basic greddy kit without intercooler would usually put out 155hp.

Braineack

iTrader: (62)

how did you measure you system at the motor? did you pull your engine and dyno it?


fwiw, if your motor DID dyno at 167BHP, your WHP would be closer to 142-145rwhp.

greendrifter

its the first car i've ever had dyno'd, it was a local garage with a rolling road, so was carried out whilst engine in the car,

thats good to know, i'll have a look for the chart and check the figures, the mechanic carried out 4 runs for me with a chart for each one, and a small improvement each time,
it may be worth mentioning i'm still running with the stock ECU so he was limited with what he could do for me,
main reason was to make sure the motor was running safe .

the main reason really for registering on here, the knowledge regarding after market ECU's and tuning, as i've taken the set up as far as i can going the DIY route, i now need to throw some money at it to squeeze the extra power out.

sixshooter

iTrader: (12)

Welcome to this forum. Do not worry about your English because many people here speak worse than you.

nofear

Thanks for the encouragement

leatherface24

iTrader: (10)

Ciao e benvenuto a bordo! Ricordatevi di ricerca prima se avete domande. Siamo stronzi a gente che non cerca

dustinb

You're hot when you talk like that.

nofear

Got it. Let's hope so.