94 FMII Link ecu to MS pnp
#9
It is recommended that you program the LC1 using your computer for 10-20:1 AFR = 1-5volts. Then in configurator set it up as LC1 linear. You should do this for the analog 2 as previously suggested.
Or you can leave it as setup default, just make sure to set it up in configurator and megatune as default. DIYautotune recommends the linear settings.
Or you can leave it as setup default, just make sure to set it up in configurator and megatune as default. DIYautotune recommends the linear settings.
#17
I have the MSPNP fully installed now. Have my LC1 Wideband connected and working properly. I used the fuel numbers above. I can not get it to start...getting good reads on all gauges in megatune. Any suggestions onto where i should start? Do i need to change any inital configurations to support the turbo on first start up? Stupid questions i know, but begginer tuner here.