96/97 Parallel EasyTherm Settings - What are you using?

Reply Subscribe

Thread Tools

Search this Thread

Jan 9, 2009 | 09:11 AM

#21

Braineack

Boost Czar

iTrader: (62)

Joined: May 2005

Posts: 80,552

Total Cats: 4,368

From: Chantilly, VA

you should just only need to copy them into the project folder. doesnt hurt to put them in every folder....

Jan 9, 2009 | 09:25 AM

#22

Saml01

Elite Member

iTrader: (9)

Joined: Jul 2007

Posts: 5,710

Total Cats: 3

From: NYC

Quote:

Originally Posted by akaryrye

hey how did you know i do that!

Anyway, i think you just told me what may be wrong ... i thought I just needed to copy the therm files into the src folder, but i need to copy them into mtcfg as well?

Yes

Quote:

Originally Posted by Braineack

you should just only need to copy them into the project folder. doesnt hurt to put them in every folder....

Yea, I still dont know exactly which folder it has to be in. So I put it in the mtcfg folder under the project, and the megasquirt folder.

Jan 9, 2009 | 11:11 AM

#23

akaryrye

Elite Member

iTrader: (5)

Joined: Jul 2006

Posts: 2,557

Total Cats: 5

From: Central California

well thats good to know, I just copied them to src because thats where the original therm files were.

Jan 9, 2009 | 11:23 AM

#24

Saml01

Elite Member

iTrader: (9)

Joined: Jul 2007

Posts: 5,710

Total Cats: 3

From: NYC

Quote:

Originally Posted by akaryrye

well thats good to know, I just copied them to src because thats where the original therm files were.

src is what you copy them into when you are compiling the firmware, it has nothing to do with megatune.

Jan 10, 2009 | 03:12 AM

#25

akaryrye

Elite Member

iTrader: (5)

Joined: Jul 2006

Posts: 2,557

Total Cats: 5

From: Central California

Ok right on. Thanks a lot guys, my coolant temps seem to be spot on now, It got up to around 200 degrees finally fully warm. I also wired the AIT directly and grounded it at the ECU ground. Seemed to read about 10 - 15 degrees warm, but Ill check it again in the morning.

Current settings are:
Coolant - RX7 defaults with 1544 bias without R4 (shared signal)
AIT - GM defaults with 2490 bias with R7 (direct signal)