looking for a '99 MS2E .msq
#2
25-ms2e-IAT-correction.msq
It's pretty conservative but I've run variations of this for about a year and a half and there has been no drama. It holds 14.5:1 at idle, 14.7 at cruse and 12 under boost. I'm still not happy with accel enrich and the idle rolls (fluctuates up and down in RPM) after a hot start. If you improve those or anything else please PM me with your fixes or post them here.
Knock sensing is disabled on this one and my stock computer controls my idle speed so it may need some work to be useful to you.
I don't think it makes a difference but I'm running the crank/cam signals through a Schmitt trigger. I think your running the op-amp setup. They should work identically but it's possible the output signals are inverted.
Also, I'm running an ancient version of the firmware. I think it's from Dec 07.
It's pretty conservative but I've run variations of this for about a year and a half and there has been no drama. It holds 14.5:1 at idle, 14.7 at cruse and 12 under boost. I'm still not happy with accel enrich and the idle rolls (fluctuates up and down in RPM) after a hot start. If you improve those or anything else please PM me with your fixes or post them here.
Knock sensing is disabled on this one and my stock computer controls my idle speed so it may need some work to be useful to you.
I don't think it makes a difference but I'm running the crank/cam signals through a Schmitt trigger. I think your running the op-amp setup. They should work identically but it's possible the output signals are inverted.
Also, I'm running an ancient version of the firmware. I think it's from Dec 07.
Thread
Thread Starter
Forum
Replies
Last Post
kotomile
Insert BS here
7
03-27-2011 05:28 AM