EBC not working
#1
EBC not working
Hi,
I installed a 3 port MAC valve on my 1993 1.6 Miata today and I have a problem. I used the options port pin-out witch says that the boost solenoid uses pin 7 so I plugged into pin 7 and and 12v source from the engine bay. I used (Test Output Mode - I/O) and pulsed Boost but nothing happed. I then went doing the line pulsing the other outputs and when I got to output2 I heard the MAC valve pulse. According to the pinout output2 in pin 25 not pin 7 so what the heck is going on here?!?!?! Was my MS2 PNP built wrong? can I rename output2 to boost and have the MS2 use that pin (pin 7) as boost control?
Thank you all for any guidance you have.
Greg
I installed a 3 port MAC valve on my 1993 1.6 Miata today and I have a problem. I used the options port pin-out witch says that the boost solenoid uses pin 7 so I plugged into pin 7 and and 12v source from the engine bay. I used (Test Output Mode - I/O) and pulsed Boost but nothing happed. I then went doing the line pulsing the other outputs and when I got to output2 I heard the MAC valve pulse. According to the pinout output2 in pin 25 not pin 7 so what the heck is going on here?!?!?! Was my MS2 PNP built wrong? can I rename output2 to boost and have the MS2 use that pin (pin 7) as boost control?
Thank you all for any guidance you have.
Greg
Thread
Thread Starter
Forum
Replies
Last Post