IAT stuck at 46*
#1
Elite Member
Thread Starter
iTrader: (41)
Join Date: Jan 2006
Location: Seabrook, TX
Posts: 2,417
Total Cats: 20
IAT stuck at 46*
I have a MS built by Braineck and the AIT is showing 46*F when that is blatantly wrong. I wired it up right to the stock afm harness, but just shows 46*. The sensor is mounted right before the throttle body and the car has only idled for a little.
Is this a firmware issue? I searched for this but all I found where people who's sensors were reading too high and they were fine before.
Is this a firmware issue? I searched for this but all I found where people who's sensors were reading too high and they were fine before.
#16
Elite Member
Thread Starter
iTrader: (41)
Join Date: Jan 2006
Location: Seabrook, TX
Posts: 2,417
Total Cats: 20
Problem solved. I'm an idiot and hooked the wire up to the 2 and 7, not 1 and 6 at the AFM. I didn't even pay attention to the wire colors because I was cocky and thought "I think I know how to count". I can, just counted them with the harness upside down.
Thread
Thread Starter
Forum
Replies
Last Post
Mikel
MEGAsquirt
4
09-28-2015 04:46 PM
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM