Car cranks but wont start. i've got my lc-2 installed and some of the optional pins plugged in to the serial plug that goes into the mspnp but they aren't connected to anything. i've attatched my logs from trying to start and my msq file.
Swapped stock ecu and it fired up first crank.

 

It's not seeing RPM. The tune is way off - for one thing, it's set to "Basic Trigger" spark mode. Try downloading the latest base map here:

MegaSquirtPNP by DIYAutoTune.com

 

Oh yea I changed that after trying to start it the first time because one of the screen captures on the instructions showed that. Standard base map and that one both had the same result. I'll make another log after work with the base map loaded.

 

Can you send me which screen cap showed that setting?

 

Checked again that's my fault that was for the general install of mspnp. I think I went if that because the spark settings didn't look the same as the ones in the instructions different versions of tuner studio?http://www.megasquirtpnp.com/docs/mspnp_g2_genInstall.php

Also does the 9697 require removal of the st sign fuse ? I saw it was required in earlier applications.

 

The ST SIGN fuse only needs to be removed on first gen 1.6 Miatas - no others.

 

new start log with base map set to fixed timing nothing else changed from base 9697 tune

 

Still no RPM. Can you make a composite log of an attempted start? This will show us what RPM signal is making it through.

 

hope this is the right log

 

It's got a cam position signal but no crank. Check the CAS wiring, and if there aren't any clear faults in the wiring, please email us directly at websales@diyautotune.com.

 

Sent y'all an email

 

I've issued a warranty return number.

 

Shipped it out in Saturday