ms3x install/setup issue
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2012
Location: Moscow, PA
Posts: 118
Total Cats: 2
ms3x install/setup issue
I believe I have everything installed per the directions I was sent by Brain, I connected my usb cable to the MS box, updated the drivers and it was assigned
COM 7, I opened tunerstudio, created a new project and when I did the
"detect" it did not find my box. When it is searching it does pause at COM 7 the longest but then continues on. I have attached a few screen shots
to hopefully help you understand where I am stuck, not sure what I
should do next. Thanks for the help
COM 7, I opened tunerstudio, created a new project and when I did the
"detect" it did not find my box. When it is searching it does pause at COM 7 the longest but then continues on. I have attached a few screen shots
to hopefully help you understand where I am stuck, not sure what I
should do next. Thanks for the help
#4
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2012
Location: Moscow, PA
Posts: 118
Total Cats: 2
Brain walked me through some things this morning, it was my TPS. My wells vTPS did not arrive yet and my MS was wired for it, leaving the stock TPS connected was causing a short, once I disconnected that everything worked. Thanks again Brain
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM