While trying to fix a different problem, I upgraded to HR 10g code. Once did, I lost the tach in MegaTune. The RPM still tracks while in the tuning screen, just no tach. Any suggestions?
--Alex

 

what is in it's place?

 

It's there. It's just red (like the guages are with the ignition off) and reads -- RPM. the wierd part is the green block on the VE table moves w/ rpm. So it has to be a software issue. I'm going to reload MT and go from there....
--Alex

 

Just reloaded MT with no change. The "Engine Speed" gauge works, the "Engine RPM" that doesn't. Not a huge deal, but a bit of a PITA.
--Alex

 

Any ideas? I thought this wouldn't be a big deal, but my daalogs don't track RPM either.
--Alex

 

its gotta be something with your msns_extra.ini file.

 

Alright, thanks for the help. I'll see what happens.
--Alex

 

I would start with fresh firmware and a freshly saved MSQ. That usually corrects strange issues like this one.

 

I reloaded my old firmware and the issure went away. High res still has the issue though. At least I know where the problem is. Thanks guys.
--Alex

 

If you're not using the newest 10G firmware of HI-RES then you should be.

 

Its 10g that's givving me the problem. Are there different releases I need to be aware of?
--Alex

 

10G is the most current and you're the first to have this issue that I know of. I suggest posting in the msextra forum to get some help with this issue.
msextra.com

 

Taken care of. I didn't run one of the batch files. My MT wasn't configured fot the 10g code. Once I ran that file, my mSec guage read down to the thousandth and the tach came back.

Thanks for the help. Back to tuning....
--Alex