New timing Map
03-24-2010, 06:32 PM
#42
Junior Member
Join Date: May 2007
Location: Columbia, MD
Posts: 248
Total Cats: 0
Yes, that can be done.
But the primaries must be run from the first 4 injector outputs on the ms3x board, and in the case you mention, you can run the secondaries in sequential off the second set of 4 ms3x outputs, or you can run the secondaries in batch semi-sequential mode off the standard v3 outputs.
Ken
But the primaries must be run from the first 4 injector outputs on the ms3x board, and in the case you mention, you can run the secondaries in sequential off the second set of 4 ms3x outputs, or you can run the secondaries in batch semi-sequential mode off the standard v3 outputs.
Ken
Reply
0
0
03-24-2010, 06:39 PM
#44
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
Yes, that can be done.
But the primaries must be run from the first 4 injector outputs on the ms3x board, and in the case you mention, you can run the secondaries in sequential off the second set of 4 ms3x outputs, or you can run the secondaries in batch semi-sequential mode off the standard v3 outputs.
Ken
But the primaries must be run from the first 4 injector outputs on the ms3x board, and in the case you mention, you can run the secondaries in sequential off the second set of 4 ms3x outputs, or you can run the secondaries in batch semi-sequential mode off the standard v3 outputs.
Ken
Reply
0
0
03-24-2010, 09:37 PM
#45
Junior Member
Join Date: May 2007
Location: Columbia, MD
Posts: 248
Total Cats: 0
We should be getting the actual boards to me and beta testers very soon (last I heard was "4 weeks," and that was about 4 weeks ago).
I'll have to ping Bruce and see.
Ken
Reply
0
0
03-25-2010, 08:49 PM
#50
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,176
Total Cats: 1,680
I got my MS3 flashed tonight. I got the car running but it would die immediately unless I gave it gas. Then as soon as I let off gas it would die again. I will be getting data logs and playing with it more tomorrow.
Reply
0
0
Probably too lean. You guys have fun. I haz no MS3.
03-25-2010, 09:09 PM
#52
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,176
Total Cats: 1,680
Might be to lean. Basically I was having errors with the msq I made when going from MS2 to MS3. So Scott sent me his clean msq file and I loaded it and just tried starting and it went. Then the battery on my laptop died so no more tuning for the night. I did forget to change my base timing setting when I loaded his map so I think that is really far off and probably has a good bit to do with it.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
