megasquirt on low imp 440s
#1
Junior Member
Thread Starter
Join Date: Jan 2007
Location: Campbell, California
Posts: 106
Total Cats: 0
megasquirt on low imp 440s
here it is... no resistors, no tricks, well, maybe some fairy dust. first of all the pics...
that's a horrible afr
idle shot
under hood
here is the video of the "impossible"
http://www.youtube.com/watch?v=8yt63J549Zo
that's a horrible afr
idle shot
under hood
here is the video of the "impossible"
http://www.youtube.com/watch?v=8yt63J549Zo
#9
Junior Member
Thread Starter
Join Date: Jan 2007
Location: Campbell, California
Posts: 106
Total Cats: 0
i'm just going to say, i dont know. they just work. i dont really have any issues, and i never have with either setup. the car runs great, i'm now at 10-11psi and climbing. my car must be magical i dont know. plus i didnt build the ms, neogenisis/braineack did.
#10
I'm using DSM 450's...
So is this guy..
http://www.msruns.com/viewtopic.php?t=10708
I must have missed the part where it says we can't use low imp?
Nice vid (not as good as your EMB one though )
So is this guy..
http://www.msruns.com/viewtopic.php?t=10708
I must have missed the part where it says we can't use low imp?
Nice vid (not as good as your EMB one though )
#11
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,501
Total Cats: 4,080
you silly guy, one of the benefits of the MS is it can run low ohm injectors without resistor packs. you might want to read up on how to correctly setup the PWM settings to run them a little better.
#13
2 Props,3 Dildos,& 1 Cat
iTrader: (8)
Join Date: Jun 2005
Location: Fake Virginia
Posts: 19,338
Total Cats: 573
That's really easy to fix with a five conductor (4x inj + ground) shielded cable, shield-grounded at the MS box (not at the injectors!). Should reject all the noise you can throw at it. You can get overkill wire by the foot at mcmaster for about $3/foot. Probably elsewhere much cheaper.
#14
Junior Member
Thread Starter
Join Date: Jan 2007
Location: Campbell, California
Posts: 106
Total Cats: 0
i'll have to look into that, sorry for kinda calling you out on that other thread. i have no idea how the plug wires were on the wrong coils i thought it was something more serious, it worked on my stock stuff. it works GREAT now, so far at 13psi and rising. and thanks for hauling *** on the shipping.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM