Dlaitini

The reason I ask this is because im currently in salt lake city, about 4400 ft above sea level

kPa is currently 86 compared to North Carolina's 100

I have set my boost controller for 182 kPa and that was supposed to be 12 psi at sea level

I have not thought too much about it and it is running fine, but then I set up a new guage in Tuner Studio to show boost, and saw that it was reading 14 psi, thats when it hit me, 100 kPa is about 14psi, and current airpressure here is 86kPa, just about 100kPa difference to what i was tuning for

Is this something i need to think to much into? or is my 14psi at this altitude going to be the same as 12 psi at sea level next time i am there?

or do i need to just ignore this psi stuff since its different depending on where i am, and only focus on kPa?

magnamx-5

iTrader: (7)

you should be fine just dont stay at max boost for 10-30 mins at a time. Unless your setup was borderline before you should have nothing to worry about.

Savington

iTrader: (31)

Perfect example of how truly arbitrary "boost" is as a measurement. I don't think you have anything at all to worry about - your ECU is still seeing 182kpa, even though your turbo is working a bit harder to get there.

What I want to know is how you managed to make a Megasquirt's closed loop boost controller work.

Fireindc

iTrader: (13)

Same situation as me. I live at 7200 ft where 12psi = 160kpa. Ambient according to my map sensor is 78kpa.

Braineack

iTrader: (62)

I'm considering upgrading to MS-II over the Christmas break for this and a few of the other extra features available.

richyvrlimited

iTrader: (1)

Same as brain, Xmas break is a perfect time too. I don't even need boost control it's full sequential town driving smoothness I want!

Dlaitini

no, ive accually have it turned down now, due to snow and ice, before i had set it for 200 kPa, thinking i would go for 14 psi. When in megalog viewer i had thought that it hitting 16 psi was spikes or something, seems now i know what was really happening now



Im using a DIY MSPNP, so not sure if that is one reason.
My "boost kpa target 1" table i had set to what kPa i was lookign for but minus 10, so i have the top row set to 170, but it will go no higher then 180.
They are from top to bottom:
170, 149, 130, 68, 50, 20

when i had it set for 200 kpa, it was
190, 170, 149, 101, 41, 0

on both the first four lower RPM cells were set to 0, since im usually less then 20% thottle when crusing, i did not want the boost controller doing anything if i am driving for hours

im sure that several of those rows are well below where the wastegate will accuate, so im not sure if it is doing anything in those cells, i spent very little time setting it up, i just set the numbers and have had it that way since