Request for someone to critique current log/program
Thread Starter
Newb
Joined: Feb 2021
Posts: 25
Total Cats: 0
Request for someone to critique current log/program
Guys,
Still very new to this and have been running some VE analyze to make improvements. The only issue I have currently is:
1) Warm car requires a blip of the throttle to start
2) If AC tuned on, car almost dies before idle up occurs
Any help appreciated!
Still very new to this and have been running some VE analyze to make improvements. The only issue I have currently is:
1) Warm car requires a blip of the throttle to start
2) If AC tuned on, car almost dies before idle up occurs
Any help appreciated!
Reply
0
0
Junior Member
Joined: Oct 2018
Posts: 412
Total Cats: 28
From: Tampa FL
1) Raise value IAC Valve opens during warm crank.
2) More complex, my suggestions are to utilize the closed loop idle initial value table and get that filled out, then consider modifying the A/C idle up page. Would recommend more of a delay on the idle up (mine is 650ms with spal fans to help prevent the dip) and a CL Load allowance being set so you aren't knocked out of closed loop idle if it jumps up a bit. 330 RPM for AC is a lot, you can set the base idle to 850 and the adder to 150 like stock and tune around those values.
2) More complex, my suggestions are to utilize the closed loop idle initial value table and get that filled out, then consider modifying the A/C idle up page. Would recommend more of a delay on the idle up (mine is 650ms with spal fans to help prevent the dip) and a CL Load allowance being set so you aren't knocked out of closed loop idle if it jumps up a bit. 330 RPM for AC is a lot, you can set the base idle to 850 and the adder to 150 like stock and tune around those values.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
