Tunerstudio settings for fans and vics
#1
Tunerstudio settings for fans and vics
I'm not really sure what to select in the output section. It has options to select 1 or 0, and then the temp/rpm. I have know idea what he 1 or 0 represents. hot, ground, open circuit, closed.
For you 90-93 guys how did you hook up your fans to ms? I ran my MS wire to the thermoswitch wire since it needs a ground to trigger. However, my fan turns on as soon as the ignition is turned on.
For you 90-93 guys how did you hook up your fans to ms? I ran my MS wire to the thermoswitch wire since it needs a ground to trigger. However, my fan turns on as soon as the ignition is turned on.
#2
you can run the thermoswitch straight to the fan relay, that will turn the fan on and off at the stock switching point independently from the MS.
or you use a spare output. 1 = closed circuit/ground. connect the trigger wire from the relay to the spare output, configure, done. i'm using one of the IAC outputs to control my fan, works great.
or you use a spare output. 1 = closed circuit/ground. connect the trigger wire from the relay to the spare output, configure, done. i'm using one of the IAC outputs to control my fan, works great.
#5
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
Set your power on value to 1 and your trigger value to 1. This will have the output off when you power up, and stay off until your target conditions are met, at which point the output will go to ground.
#10
Ben, thanks. I will remove the pullups. As is, it appears to always be in a grounded state since no matter what the settings it always has the fans running.
PS. I have a running vehicle now! I'm hoping to get to DIY in June or July for dyno tuning. How's the dyno schedule looking? Will I get all aspects of MS tuned? Spark, fuel, EBC, idle, etc???
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM