Unresolved MS issues
Thread Starter
Junior Member
Joined: Dec 2007
Posts: 297
Total Cats: 0
From: San Diego to LA, CA
Unresolved MS issues
I have a DIY Megasquirt V3, it runs fine I just have some issues that are really irking me.
1. Running DIY PNP 90-93 basemap the Fan/Output 4 bar on the bottom of MegaTune is always on, but that is not hooked up to fan. My fan is connected to output two and this works properly. what corresponds to output 4 so i can figure this out?
2. My Idle DC was at like 150% and counting up today when I was idleing after about 15 miles of driving. What is up with this? Is it due to the idle valve itself? Mind you, I am running the DIY PNP basemaps with only the timing set and some adjustments.
Anyone help will be appreciated
1. Running DIY PNP 90-93 basemap the Fan/Output 4 bar on the bottom of MegaTune is always on, but that is not hooked up to fan. My fan is connected to output two and this works properly. what corresponds to output 4 so i can figure this out?
2. My Idle DC was at like 150% and counting up today when I was idleing after about 15 miles of driving. What is up with this? Is it due to the idle valve itself? Mind you, I am running the DIY PNP basemaps with only the timing set and some adjustments.
Anyone help will be appreciated
Reply
0
0
Supporting Vendor
Joined: Sep 2006
Posts: 2,332
Total Cats: 67
If output 4 is off, its reading in MegaTune is kind of indeterminate. Just ignore it. Is the car idling correctly?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
Jan 8, 2021 11:24 AM
