VICS in Brain-Built MS3
I'm hoping you all can help with this, since I can't seem to get ahold of Braineack over email:
Does anyone know if Brain wires up his harnesses to support VICS control in 99-00 cars? If so, where do I control it from? I know there are several outputs, but wasn't able to figure out which (if any) are hooked to it.
Car is an N/A 99 with the stock motor.
Does anyone know if Brain wires up his harnesses to support VICS control in 99-00 cars? If so, where do I control it from? I know there are several outputs, but wasn't able to figure out which (if any) are hooked to it.
Car is an N/A 99 with the stock motor.
I thought we took care of this in the last msq i sent you? (but not sure how i missed your last few emails looking back--still need help regarding that issue?).
it should be INJ E under programmable inputs and outputs.
Active On
rpm > 5252 | 10
it should be INJ E under programmable inputs and outputs.
Active On
rpm > 5252 | 10
No worries, thanks! We did take care of the high idle issue with the last tune you sent, and I was able to fix the sync issue at high RPM yesterday, so it's looking pretty good at this point.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
Oct 26, 2018 11:00 PM







